30N PNEUMATIC Clamp Mesh Table

The method of using a semi-automatic screen double-chuck pneumatic screen stretching machine mainly includes the following steps:

Preparation phase:

Make sure that the pneumatic source is available. Sometimes a compressed air cylinder can be used instead of a compressed air pump.
Place the screen frame on the screen stretching table and lay the screen horizontally against the screen frame.
Fix the screen:

Fix the screen around the chuck and tighten it according to the required tension.
Apply adhesive to the contact surface between the screen frame and the screen.
Adjust the chuck:

If the chuck does not clamp the screen tightly, it can be solved by adjusting the screws above the chuck or replacing the rubber strip.
If the chuck is not stretched and retracted consistently, the air intake can be made consistent by adjusting the flow valve, cleaning and lubricating the piston rod, and checking whether the oil mist is oily or dripping.
Daily maintenance:

Ensure that the drainage filter must be drained every shift, check the lubrication of the sliding guide rail, check whether there is foreign matter stuck in the machine operation range, and clean the machine surface.
The whole machine must be lubricated, oiled, and mechanical parts must be inspected and tightened every week.
‌Tips for use‌:

Use a soft pen to draw lines to observe whether the clamping force of each chuck is consistent to ensure that the tension is evenly distributed.
Through the above steps, the semi-automatic screen double-chuck pneumatic screen tensioning machine can be effectively used to tighten the screen to ensure the stability of the screen and the printing quality during the printing process‌12.